What are the steps to use the Rapid Remover?

Modified on Tue, 15 Apr at 4:56 PM

First, gently buff off your Top Coat. Then, apply our Rapid Remover to each nail following the instructions and wait approximately 5-8 minutes. The remover should still be tacky, and at this point, you can push it off with an Orange stick, removing the application along with it. Push from the base of the nail towards the tip. Reapply to any stubborn areas. If you have long nails, support the tips from underneath as you push off the product to increase friction. After use, replace the cap and screw it on tightly.

You will find the detailed steps here - How To Remove (sistaco.com)

Here are some top tips :

When using, it will NOT work better, the longer you leave it on.DO buff off the Top Coat - this is VERY IMPORTANT as the RR cannot penetrate through a Top Coat seal.

DO slightly heap on the nail
DO NOT allow it to dry on the nail to a hard consistency; it should still be slightly 'gooey' when pushed off. The timing on this may vary depending on where you are based. Maybe do a couple of nails at a time to get this right, initially.
DO use the flat edge of an orange stick to push off.
ALWAYS push from the base of the nail to the tip of the nail, ensuring you get under your application from the base of your nail; right at the start and pushing upwards.
DO Apply Sistaco Elixir to nourish afterwards.
DO make sure your lid of the RR is tightly screwed on at all times.

Remember though that a system that is designed to stay will take a little time to remove. Be patient and do not scrape your nails plate or peel off your application as this will weaken the nail.